1Y0-253 Citrix NetScaler 10.5 Sample Questions

Below are four sample questions from the 1Y0-253 Citrix NetScaler 10.5 for App and Desktop Solutions CCA-N certification exam. These sample questions can be found in the 1Y0-253 Exam Preparation Guide on Citrix Education's website.

Sample Question 1

Objective: Determine the authentication methods in the environment

Which two tasks must a Citrix Administrator complete to enable Client Certificate Authentication on the NetScaler Gateway? (Choose two.)

A. Create a pre-authentication policy.
B. Create an LDAP authentication policy.
C. Import the root certificate onto the NetScaler Gateway.
D. Import all client certificates onto the NetScaler Gateway.
E. Enable the Client Authentication option on the virtual server.

Answers: C and E

Source: Citrix Docs - http://docs.citrix.com/en-us/netscaler-gateway/10-5/ng-configuration-mgmt-wrapper-con/ng-authen-authoriz-wrapper-con/ng-client-cert-configuration-tsk.html

Sample Question 2

Objective: Install/configure SSL Certificates

Which two default key formats of SSL certificates could be installed by the NetScaler system? (Choose two.)

B. P7B

Answers: C and D

Source: Citrix Support – http://support.citrix.com/article/CTX109260

Sample Question 3

Objective: Configure Clustering

What is required to configure a NetScaler Gateway cluster?

A. Striped IP addresses
B. Strict option is enabled
C. Sticky option is enabled
D. Enterprise or Platinum license

Answer: C

Source: Citrix Docs - http://docs.citrix.com/en-us/netscaler-gateway/10-5/ng-configuration-mgmt-wrapper-con/ng-cluster-con/ng-cluster-conf-tsk.html

Sample Question 4

Objective: Upgrade a NetScaler

Scenario: A Citrix Administrator is upgrading a high availability pair to NetScaler 10.5. After upgrading the secondary appliance, the administrator forces a failover to test the new firmware, but the show ha node command shows the sync state and propagation as disabled.

Why are the settings showing as disabled?

A. The appliances did NOT properly failover.
B. The NSIPs are no longer able to communicate.
C. The settings are automatically disabled until the other appliance is upgraded.
D. The upgrade process failed to run to completion on the secondary appliance.

Answer: C

Source: Citrix Docs - http://docs.citrix.com/en-us/netscaler/10-5/ns-gen-migration-wrapper-con-10/ns-instpk-upgrd-dwngrd-sys-sw-wrapper-con/ns-instpk-upgrd-release-con.html

Comments are closed.